Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| network_protocol_programming_lab:change_frequency [2021/04/19 12:39] – [Tasks] rathke | network_protocol_programming_lab:change_frequency [2021/04/19 12:40] (current) – [Tasks] rathke | ||
|---|---|---|---|
| Line 30: | Line 30: | ||
| * In your program, set RF to an arbitrary value (e.g. 851 MHz) within the supported frequency band of CC1200. | * In your program, set RF to an arbitrary value (e.g. 851 MHz) within the supported frequency band of CC1200. | ||
| * In SmartRF Studio also change the symbol rate to 1.2 kBaud and the preamble count to 6 Bytes. | * In SmartRF Studio also change the symbol rate to 1.2 kBaud and the preamble count to 6 Bytes. | ||
| - | * Bring SmartRF Studio | + | * Bring 4C in “TX Packet Mode" |
| * start the transmitter. At the receiver, the BeagleBone Black, you should now receive **NO** packet. | * start the transmitter. At the receiver, the BeagleBone Black, you should now receive **NO** packet. | ||
| * Now, stop the transmitter and change the frequency to your selected frequency. | * Now, stop the transmitter and change the frequency to your selected frequency. | ||
