Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| network_protocol_programming_lab:robust [2020/06/02 09:50] – [Tasks] rathke | network_protocol_programming_lab:robust [2021/04/19 12:43] (current) – [Requirements] rathke | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| This task requires | This task requires | ||
| - | * a ready BeagleBone Black equipped with the CC1200 | + | * a ready BeagleBone Black equipped with the CC1200. |
| - | * one TI Development Kit for the CC1200. | + | * 4C attached to a second BeagleBone Black equipped with the CC1200. |
| - | * Smart RF Studio | + | * 4C sending packets with a symbol rate of 1.2 kBaude and a preamble count of 6 Bytes. |
| ===== Tasks ===== | ===== Tasks ===== | ||
| Line 22: | Line 21: | ||
| * Extend your program to control packet reception by timers. | * Extend your program to control packet reception by timers. | ||
| * For testing, start your program and use the same test scenarios used by [[network_protocol_programming_lab: | * For testing, start your program and use the same test scenarios used by [[network_protocol_programming_lab: | ||
| - | * If an error occurs, your program should continue receiving packets. | + | * If an error occurs, your program should continue receiving packets. |
| ===== Hints ===== | ===== Hints ===== | ||
