Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| network_protocol_programming_lab:scanning [2020/06/05 08:59] – [Tasks] rathke | network_protocol_programming_lab:scanning [2021/04/19 12:42] (current) – [Tasks] rathke | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| This task requires | This task requires | ||
| - | * a ready BeagleBone Black equipped with the CC1200 | + | * a ready BeagleBone Black equipped with the CC1200. |
| - | * one TI Development Kit for the CC1200. | + | * 4C attached to a second BeagleBone Black equipped with the CC1200. |
| - | * Smart RF Studio | + | * 4C sending packets with a symbol rate of 1.2 kBaude and a preamble count of 6 Bytes. |
| ===== Tasks ===== | ===== Tasks ===== | ||
| Line 17: | Line 16: | ||
| * Limit the number of frequencies to 3 (e.g. 850MHz, 820MHz and 950MHz). Die frequencies are chosen to be the lowest supported , the highest supported frequency and a frequency between them. | * Limit the number of frequencies to 3 (e.g. 850MHz, 820MHz and 950MHz). Die frequencies are chosen to be the lowest supported , the highest supported frequency and a frequency between them. | ||
| * For testing, start your program. | * For testing, start your program. | ||
| - | * Use SmartRF Studio | + | * Use 4C to transmit packets at the RF frequency of your supported frequency set.(do not forget to change the symbol rate and preamble count in 4C). |
| * Your program should recognize a valid RSSI and start receiving packets. | * Your program should recognize a valid RSSI and start receiving packets. | ||
| * Now, change RF to a frequency to another frequency band. Stopping and restarting the transmitter ist not necessary. | * Now, change RF to a frequency to another frequency band. Stopping and restarting the transmitter ist not necessary. | ||
