This is an old revision of the document!
Exercise: Changing the frequency
It is obvious, that changing the RF frequency is a fundamental requirement of frequency hopping systems. Programming the RF frequency is done according chapter 9.1.2 of CC1200 Users Guide.
In detail, the HF $f_{VCO}$ frequency is computed by:
$$ f_{RF}=\frac{f_{VCO}}{"LO\ Divider} $$
where
$$ f_{VCO} = \frac{FREQ}{2^{16}} . f_{XOSC} + \frac{FREQOFF}{2^{18}} . f_{XOSC}$$
In this two equations $f_{XOSC}$ is the crystal frequency of the TI boards and equal to $40 MHz$. LO Divider“ determines the frequency band of the CC1200 and will be programmed by the FSD_BANDSELECT part of the “Frequency Synthesizer Configuration” -register (FS_CFG'' -register).
